DGS-3710 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
57
Format
config radius delete <server_index 1-3>
Parameters
<server_index 1-3>
- Specifies the RADIUS server index. The range is from 1 to 3.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To delete a RADIUS server:
DGS-3710-12C:admin#config radius delete 1
Command: config radius delete 1
Success.
DGS-3710-12C:admin#
4-23
config radius
Description
This command is used to configure a RADIUS server.
Format
config radius <server_index 1-3> {ipaddress [<server_ip> | <ipv6addr>] | key <passwd 32> |
auth_port [<udp_port_number 1-65535> | default] | acct_port [<udp_port_number 1-65535> |
default] | timeout [<int 1-255> | default] | retransmit [<int 1-20> | default]}(1)
Parameters
<server_index 1-3>
- Specifies the RADIUS server index.
ipaddress
- Specifies the IP address of the RADIUS server.
<server_ip>
- Enter the RADIUS server IP address here.
<ipv6addr>
- Enter the RADIUS server IPv6 address here.
key
- Specifies the key pre-negotiated between the switch and the RADIUS server. It is used to
encrypt user’s authentication data before being transmitted over the Internet. The maximum
length of the key is 32.
<passwd 32>
- Specifies the key pre-negotiated between the switch and the RADIUS server.
It is used to encrypt user’s authentication data before being transmitted over the Internet.
The maximum length of the key is 32.
auth_port
- Specifies the UDP port number which is used to transmit RADIUS authentication
data between the switch and the RADIUS server. The default is 1812.
<udp_port_number 1-65535>
- The authentication port value must be between 1 and 65535.
default
- Specifies to use the default value.
acct_port
- Specifies the UDP port number which is used to transmit RADIUS accounting
statistics between the switch and the RADIUS server. The default is 1813.