Инструкция для D-LINK DGS-3710-12C

(скачивание инструкции бесплатно)

Формат файла: PDF

Доступность: Бесплатно как и все руководства на сайте. Без регистрации и SMS.

Дополнительно: Чтение инструкции онлайн

DGS-3710 Series Layer 2 Managed Gigabit Switch CLI Reference Guide

737

Appendix D - RADIUS Attributes

Assignment

The RADIUS Attributes Assignment on the Switch is used in the following modules: 802.1X (Port-
based and Host-based), Web-based Access Control, and MAC-based Access Control.

The description that follows explains the following RADIUS Attributes Assignment types:

1. Ingress/Egress Bandwidth

2. 802.1p Default Priority

3. VLAN

To assign

Ingress/Egress bandwidth by RADIUS Server

, the proper parameters should be

configured on the RADIUS Server. The tables below show the parameters for bandwidth.

The parameters of the Vendor-Specific attributes are:

Vendor-Specific Attribute Description

Value

Usage

Vendor-ID

Defines the vendor.

171 (DLINK)

Required

Vendor-Type

Defines the attribute.

2 (for ingress
bandwidth)

3 (for egress
bandwidth)

Required

Attribute-Specific Field

Used to assign the bandwidth
of a port.

Unit (Kbits)

Required

If the user has configured the bandwidth attribute of the RADIUS server (for example, ingress
bandwidth 1000Kbps) and the 802.1X authentication is successful, the device will assign the
bandwidth (according to the RADIUS server) to the port. However, if the user does not configure
the bandwidth attribute and authenticates successfully, the device will not assign any bandwidth to
the port. If the bandwidth attribute is configured on the RADIUS server with a value of “0”, the
effective bandwidth will be set to “no_limited”, and if the bandwidth is configured to be less than “0”
or greater than the maximum supported value, the bandwidth will be ignored.

To assign

802.1p default priority by RADIUS Server

, the proper parameters should be

configured on the RADIUS Server. The tables below show the parameters for 802.1p default
priority.