DGS-3710 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
287
Parameters
all
- Specifies to configure all VLANs and VLAN IDs.
vlan_name
- Specifies the VLAN name to be configured.
<vlan_name>
- Specifies the VLAN name.
vlanid
- Specifies the VLAN ID to be configured.
<vlanid_list>
- Specifies a list of VLAN IDs.
state
- Specifies whether to enable or disable the data driven learning of an IGMP snooping
group. This is enabled by default.
enable
- Enable data driven learning of an IGMP snooping group.
disable
- Disable data driven learning of an IGMP snooping group.
aged_out
- Enable or disable the aging of the entry. This is disabled by default.
enable
- Enable the aging of the entry.
disable
- Disable the aging of the entry.
expiry_time
- Specifies the data driven group lifetime in seconds. This parameter is valid only
when
aged_out
is enabled.
<sec 1-65535>
- Specifies the time between 1 and 65535 seconds.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To enable data driven learning of an IGMP snooping group on a default VLAN:
DGS-3710-12C:admin# config igmp_snooping data_driven_learning vlan_name default
state enable
Command: config igmp_snooping data_driven_learning vlan_name default state
enable
Success.
DGS-3710-12C:admin#
27-17
config igmp_snooping data_driven_learning
max_learned_entry
Description
This command is used to configure the maximum number of groups that can be learned by the
data driven mechanism. When the table is full, the system will stop learning new data-driven
groups. Traffic for the new groups will be dropped.
Format
config igmp_snooping data_driven_learning max_learned_entry <value 1-1024>
Parameters
<value 1-1024>
- Specifies the maximum number of groups that can be learned by the data
driven mechanism. The default is 128.