DGS-3710 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
356
35-2
delete link_aggregation group_id
Description
This command is used to delete a previously configured link aggregation group.
Format
delete link_aggregation group_id <value 1-6>
Parameters
<value 1-6>
- Specifies the group ID. The group number identifies each of the groups. The switch
allows up to 6 link aggregation groups to be configured.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To delete a link aggregation group:
DGS-3710-12C:admin#delete link_aggregation group_id 3
Command: delete link_aggregation group_id 3
Success.
DGS-3710-12C:admin#
35-3
config link_aggregation group_id
Description
This command allows you to configure a link aggregation group that was created with the
create
link_aggregation
command above.
Format
config link_aggregation group_id <value 1-6> {master_port <port> | ports <portlist> | state
[enable | disable]}(1)
Parameters
<value 1-6>
- Specifies the group ID. The group number identifies each of the groups. The switch
allows up to 6 link aggregation groups to be configured.
master_port
- Specifies which port (by port number) of the link aggregation group will be the
master port. All of the ports in a link aggregation group will share the port configuration with
the master port.
<port>
- Specifies the master port ID.
ports
- Specifies a range of ports that will belong to the link aggregation group. The port list
should include the master port.
<portlist>
- Specifies a range of ports to be configured.