DGS-3710 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
167
Format
config authentication guest_vlan [vlan <vlan_name 32> | vlanid <vlanid 1-4094>] [add |
delete] ports [<portlist> | all ]
Parameters
vlan
- Specifies the guest VLAN name.
<vlan_name 32>
- Specifies the guest VLAN name. The VLAN name can be up to 32
characters long.
vlanid
- Specifies the guest VLAN VID.
<vlanid 1-4094>
- Specifies the guest VLAN VID. The VLAN ID value must be between 1 and
4094.
add
- Specifies to add a port list to the guest VLAN.
delete
- Specifies to delete a port list from the guest VLAN.
ports
- Specifies a port or range of ports to configure.
<portlist>
- Specifies a range of ports to configure.
all
- Specifies to configure all ports.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To configure authentication for all ports for a guest VLAN called “gv”:
DGS-3710-12C:admin#config authentication guest_vlan vlan gv add ports all
Command: config authentication guest_vlan vlan gv add ports all
Success.
DGS-3710-12C:admin#
15-4
config authentication ports
Description
This command is used to configure authorization mode and authentication method on ports.
Format
config authentication ports [<portlist> | all] {auth_mode [port_based | host_based] |
multi_authen_methods [none | any | dot1x_impb | impb_wac | mac_impb]}(1)
Parameters
<portlist>
- Specifies a port or range of ports to configure.
all
- Specifies to configure all ports.
auth_mode
- The authorization mode is port-based or host-based.
port-based
- If one of the attached hosts pass the authentication, all hosts on the same port
will be granted access to the network. If the user fails the authorization, this port will keep
trying the next authentication.
host-based
- Specifies to allow every user to be authenticated individually.