DGS-3710 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
556
54-2
disable qinq
Description
This command is used to disable Q-in-Q. When Q-in-Q is disabled, all dynamic learned L2
addresses will be cleared, all dynamic registered VLAN entries will be cleared, and GVRP will be
disabled. To run GVRP on the switch, the administrator should enable GVRP manually.
Format
disable qinq
Parameters
None.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To disable Q-in-Q:
DGS-3710-12C:admin#disable qinq
Command: disable qinq
Success.
DGS-3710-12C:admin#
54-3
show qinq
Description
This command is used to display the global Q-in-Q status.
Format
show qinq
Parameters
None.
Restrictions
None.