![background image](/i/d-link/144853/d-link-dgs-3710-12c/h/d-link-dgs-3710-12c-227.png)
DGS-3710 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
223
Restrictions
Only Administrator-level users can issue this command.
Example
To configure the time out value for ping packets:
DGS-3710-12C:admin#config dhcp ping_timeout 500
Command: config dhcp ping_timeout 500
Success.
DGS-3710-12C:admin#
19-17
create dhcp pool manual_binding
Description
This command is used to specify the distinct identification of the client in dotted-hexadecimal
notation or hardware address, for example, 0122.b708.1388, where 01 represents the Ethernet
media type and the IP address pair.
An address binding is a mapping between the IP address and MAC address of a client. The IP
address of a client can be assigned manually by an administrator or assigned automatically from a
pool by a DHCP server. The dynamic binding entry will be created when an IP address is assigned
to the client from the pool network’s address. For this command, if the type is not specified, then
the type will be Ethernet. For the match operation, the hardward type and the hardware address
field in the protocol fields will be used to match against the entry. The IP address specified in the
manual binding entry must be in a range within that the network uses for the DHCP pool. If the
user specifies a conflict IP address, an error message will be returned. If a number of manual
binding entries are created, and the network address for the pool is changed such that conflicts are
generated, those manual binding entries which conflict with the new network address will be
automatically deleted.
Format
create dhcp pool manual_binding <pool_name 12> <ipaddr> hardware_address <macaddr>
{type [Ethernet | IEEE802]}
Parameters
<pool_name 12>
- Specifies the DHCP pool name.
<ipaddr>
- Specifies the IP address which will be assigned to a specified client.
hardware_address
- Specifies the hardware MAC address.
<macaddr>
- Enter the MAC address here.
type
- (Optional) Specifies the DHCP pool manual binding type.
Ethernet
- Specifies Ethernet type.
IEEE802
-Specifies IEEE802 type.
Restrictions
Only Administrator-level users can issue this command.