DGS-3710 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
309
Parameters
<network_address>
- (Optional) Specifies the destination network address of the route want to
be displayed..
<ipaddr>
- (Optional) Specifies the destination IP address of the route want to be displayed. The
longest prefix matched route will be displayed.
static
- (Optional) Specifies to display only static routes. One static route may be active or
inactive.
Restrictions
None.
Example
To display the contents of the IP routing table:
DGS-3710-12C:admin#show iproute
Command: show iproute
Routing Table
IP Address/Netmask Gateway Interface Cost Protocol
------------------ --------------- ------------ -------- --------
10.0.0.0/8 0.0.0.0 System 1 Local
Total Entries : 1
DGS-3710-12C:admin#
29-4
create ipv6route
Description
This command is used to create an IPv6 static route in the switch’s IP routing table. If the next hop
is a global address, it is not necessary to indicate the interface name. If the next hop is a link local
address, then the interface name must be specified.
Format
create ipv6route [default | <ipv6networkaddr>] [<ipif_name 12> <ipv6addr> |<ipv6addr>]
{<metric 1-65535>} {[primary | backup]}
Parameters
default
- Specifies the default route.
<ipv6networkaddr>
- Specifies the destination network for the route.
<ipif_name 12> <ipv6addr>
- Specifies the interface for the route.
<ipv6addr>
- Specifies the next hop address for this route.
<metric 1-65535>
- (Optional) The default setting is 1.
primary
- (Optional) Specifies the route as the primary route to the destination.
backup
- Specifies the route as the backup route to the destination. If the route is not specified
as the primary route or the backup route, then it will be auto-assigned by the system. The first
created is the primary, the second created is the backup.