DGS-3710 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
469
Format
create trusted_host [<ipaddr> | <ipv6addr> | network <network_address> | ipv6_prefix
<ipv6networkaddr>] {snmp | telnet | ssh | http | https | ping}
Parameters
<ipaddr>
- Specifies the IP address of the trusted host.
<ipv6addr>
- Specifies the IPv6 address of the trusted host.
network
- Specifies the network address of the trusted network. The form of network address is
xxx.xxx.xxx.xxx/y.
<network_address>
- Specifies the network address of the trusted network. The form of
network address is xxx.xxx.xxx.xxx/y.
ipv6_prefix
- Specifies the IPv6 network address of the trusted network.
<ipv6networkaddr>
- Specifies the IPv6 network address of the trusted network.
snmp
- (Optional) Specifies the trusted host for SNMP.
telnet
- (Optional) Specifies the trusted host for Telnet.
ssh
- (Optional) Specifies the trusted host for SSH.
http
- (Optional) Specifies the trusted host for HTTP.
https
- (Optional) Specifies the trusted host for HTTPs.
ping
- (Optional) Specifies the trusted host for Ping.
Note:
If no management method is specified, the IP (range) can access the Switch
through any method.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To create a trusted host:
DGS-3710-12C:admin#create trusted_host 10.48.74.121
Command: create trusted_host 10.48.74.121
Success.
DGS-3710-12C:admin#
46-4
config trusted_host
Description
This command is used to configure the access method for the trusted host.
Format
config trusted_host [<ipaddr> | <ipv6addr> | network <network_address> | ipv6_prefix
<ipv6networkaddr>] [add | delete] [{snmp | telnet | ssh | http | https | ping} | all]